Gutter genius: a raindrop in a hard hat, harness and gloves works on the gutter from a ladder footed by a co-worker in a hard hat and hi-vis vest; the downpipe leads roof water into a smiling tank

Based on a paper by Dr Terry Thomas, edited by Han Heijnen

Eight instrumented mini systems, a survey of 56 houses and a simplified guttering kit: a year of trials in four districts of western and northern Uganda points the way to low-cost roofwater harvesting for households.

In a year-long experiment in low-cost roofwater harvesting in Uganda, eight instrumented mini systems delivered an average of 37 litres a day over the measurement period, from March to November. Each system costs about USD 100. Valuing the labour of fetching water at an estimated USD 5 per 1,000 litres, a system that yields its target of 13,000 litres a year pays for itself in about 18 months. And the neighbours of the eight demonstration homes showed more interest in a single system (40 litres a day) than in a double one (80 litres a day).

A year of trials in Uganda, in figures

8

instrumented mini systems in four districts

37 litres

a day on average, March to November

about USD 100

per system

18 months

to pay for itself, if fetching labour is valued at USD 5 per 1,000 litres

Dr Terry Thomas, a retired professor of engineering at the University of Warwick (UK) with a long association with Uganda, led the experiment in collaboration with IRHA. It builds on the first mini-RWH installations in Kasese, in early 2025.

Why storage is the hard part

Roofwater harvesting is capital-intensive, because the water has to be stored. “Informal” harvesting with buckets is cheap, but it stores only one or two days of water, is often unhygienic and captures about a quarter of a roof’s annual runoff. “Full” harvesting, with a tank holding several weeks of consumption, captures 80% or more, but it may cost around USD 2,000 per household.

Plenty of rain, little harvested

Uganda generally receives more than 1,200 mm of rain a year, in two wet and two dry seasons, and metal or tile roofs have replaced grass. A typical roof sheds around 40,000 litres a year. Yet rainwater supplies only a tiny fraction of rural domestic water. Most of it is still fetched from wells, springs and boreholes.

The mini system

The aim was a mini system providing 80 litres a day for ten months of the year, replacing about 80% of the effort spent collecting water, for around USD 200 per household. It is not meant to be the only water source: it adds to water security. It works alongside the wells, springs and boreholes that families already use, and spares them many of the daily trips.

The 2025 model matches a 20 m² catchment, one face of a typical double-pitched house, to a widely available 500-litre HDPE tank. Its target yield is 13,000 litres a year, so a household would need two systems to reach 80 litres a day.

What was measured

The design was developed in Kampala. Technician Victor Turyamureba then built eight instrumented systems in four districts of western and northern Uganda, including Amuru District, with local fundis (craftspeople) watching. A survey of 56 houses found that people use about 15 litres per person per day and spend on average 40 minutes fetching each 21-litre jerrycan. Young people with bicycles are paid USD 0.10 per jerrycan, and fetched water is generally perceived as good.

Simpler by design

Training fundis across Uganda’s roughly 2,000 sub-counties would be uneconomic. Instead, the paper recommends marketing a guttering kit. Installation should take travel time plus four person-hours, with common tools and a rivet gun in the kit. The design was simplified accordingly:

Where the money goes

Of the roughly USD 100 per system, 40% goes to the tank and tap, 30% to the guttering kit, and 30% to assembly by the fundi, local marketing and the plinth.

ItemShare of the cost
Tank and tap40%
Guttering kit30%
Assembly by the fundi, local marketing and plinth30%
Total per systemabout USD 100
Where the money goes, from Dr Terry Thomas’s paper (2025).

Open questions

Questions remain on affordability for households, which of three distribution routes suits the kits, the types of household to target, and whether manufacturing and installation can pay their way for producers and fundis. Manufacture of the guttering kits has started in Kampala, and the method is now under trial in several districts.

Three points for practitioners

For anyone planning household rainwater systems, three points stand out: start small, with one face of a roof and a standard 500-litre tank; drop what people do not use; and let households choose the size. For a larger tank built by local masons, see our Calabash Tank Manual.

Learn more about our Rainwater for WASH programme.

Stay in touch: follow our upcoming events and our latest news.

Added to our news archive in November 2026.